Xbox 360 slim jtagging is possible, but it’s not easy. There are a few required tools and some complicated steps involved. If you’re determined to try it, be prepared for a long and frustrating process. Xbox 360 slim jtagging is possible, but it’s not easy. There are a few required tools and some complicated steps involved. If you’re determined to try it, be prepared for a long and frustrating process. If you want to jtag your Xbox 360 slim, you’ll need the following: an Xbox 360 slim console (obviously), an Xbox 360 JTAG adapter (available online or at certain electronics stores), a USB cable (to connect the adapter to the console), and some knowledge of how to use these tools. The first step is to remove the cover of the console by unscrewing the six screws that hold it in place. Once it’s loose, carefully pull it off so that you have access to all of the internal components. Next, connect your JTAG adapter to your console using the USB cable. Make sure that both devices are powered on—the adapter will come with instructions on how to do this—and then press down on the center button on the adapter until a green light starts flashing rapidly. This indicates that your device is in communication with the computer; keep pressing down until this light turns off completely, which should happen after about 10 seconds or so. Now comes the tricky part: You need to start up your Xbox 360 slim without any discs in it by pressing down on its power button for about 10 seconds until its blue light starts flashing rapidly; once this happens, release the power button and insert one of your original discs into one of its optical drives (you can use any disc). Once your disc has been inserted correctly, press down on both buttons at once again—this time keeping them pressed until you see a message onscreen telling you that jtag ..
